How to install lights & flags

 

1) Bolt light boards onto bin having the outer edge of flags flush with the outside of wheel.

Flag 1

2) Thread the two cables through the top RHS sections on each side of the machine, then cable tie them together down the front bars. Joining them together on one side.

Flag 2 copyFlag 3

3) Cut the two cables 1.5 metres past tow eye and wire on plug. PTO.

Cut wires

4)  Follow this wiring diagram. Making sure the correct coloured wires correspond with the correct locations.

 

Wiring set up

5) Test the lights. If you have any trouble call your local dealer or contact SAM Machinery directly.